Axial Lead Transient Voltage Suppressors (TVS) Revision October 18, 20131 / 7 The 5KP series is designed specificallyto protect sensitive electronic equipment from voltage transients induced by lightning and other transient voltage events.Uni-directionalBi-directional u Low leakageu Uni and Bidirectional unit u Excellent clamping capabilityu 5000W Peak power capability at 10 × 1000µs waveform Repetition rate (duty cycle):0.01%u Fast response time: typically less than 1.0ps from 0 Volts to V BR min u Typical I R less than 5μA above 12V.u High Temperature soldering: 260°C/40 seconds at terminals u Typical maximum temperature coefficient ΔV BR = 0.1% × V BR @25°C × ΔTu Plastic package has Underwriters Laboratory Flammability 94V-0 u Matte tin lead –free Platedu Halogen free and RoHS compliantu Typical failure mode is short from over-specified voltage or current u Whisker test is conducted based on JEDEC JESD201A per its table 4a and 4cu IEC-61000-4-2 ESD 15kV(Air), 8kV (Contact)u ESD protection of data lines in accordance with IEC 61000-4-2 (IEC801-2)uEFT protection of data lines in accordance with IEC 61000-4-4 (IEC801-4) TVS devices are ideal for the protection of I/O interfaces, V bus and other vulnerable circuits used in Telecom, Computer, Industrial and Consumer electronic applications. ParameterSymbolValueUnitPeak Pulse Power Dissipation with a 10/1000µs waveform (Fig.1)(Note 1), (Note 2)P PPM 5000 Watts Peak Pulse Current with a 10/1000µs waveform.(Note1,Fig.3) I PP See Next TableAmps Power Dissipation on Infinite Heat Sink at T L =75°CP M(AV) 8.0 Watt Peak Forward Surge Current, 8.3ms Single Half Sine Wave (Note 3) I FSM 500 Amps Maximum Instantaneous Forward Voltage at 25A for Unidirectional Only (Note 4)V F 3.5/5.0 Voltage Operating junction and Storage Temperature Range.T J , T STG-55 to +150°CNotes:1. Non-repetitive current pulse, per Fig. 3 and derated above T A = 25°C per Fig.2. 2. Mounted on 5.0mm x 5.0mm (0.03mm thick) Copper Pads to each terminal.3. 8.3ms single half sine-wave, or equivalent square wave, Duty cycle = 4 pulses per minutes maximum.4. V F < 3.5V for V BR < 200V and V F < 6.5V for V BR > 201V.
本文来源：https://www.2haoxitong.net/k/doc/2470a6b5970590c69ec3d5bbfd0a79563c1ed434.html
