ATM SWITCHStARTM Reference Design CD-ROM
Thank you for your interest in IDT's SWITCHStAR products and
the IDT77950 ATM Switch Reference Design. Please print this file for you reference.
Right click on your CD-ROM drive to access the remaining files after printing and
reviewing this file.
This CD-ROM is organized to provide you with all of the information
that you will need to use the IDT77950.
+ Product Documentation Folder (All files are in Adobe Acrobat format)
IDT77155 Information
IDT779145 Information
IDT77950 Data Sheet, Advancenet and SwitchBIOS Software Information
Board Schematics
SWITCHStAR Data Sheets and User Manual Sections 1-3
+ AdvanceNet Files
WinATM_Lite v1.19 drivers for the IDT779145 NIC from AdvanceNet Systems Inc.
+ SwchBIOS Folder
Manuals, Code and Installation for the SwitchBIOS software
Software Installation Sequence:
1. Load the CD-ROM and print out both swbRef.pdf and swbUser.pdf from the
SwchBIOS/Manuals folder. The swbRef.pdf file is the SwitchBIOS Programmer's Guide.
The swbUser.pdf is the SwitchBIOS User's Manual. The User's Manual includes function
definitions and operational information. Refer to page 66 of the User's Manual for
the written instructions on installing the AdvanceNet Systems driver for the IDT779145
NICStAR board. It is also strongly recommended that you also print out Advancenet.pdf
from the Product Documentation/Idt77950 folder (8 pages) to further assist with the
AdvanceNet driver installation.
2. Power down the computer and install the IDT779145 NICStAR card in your
computer. Make sure that you have uninstalled any other NIC software that
was already installed on the system.
3. As the machine is powered back up the system will search for the IDT779145
driver. Specify d:/
letter for your CD-ROM drive. Use the Serial Number provided on the label
of the CD-ROM. When prompted for the ESI address either enter the unique
address if network operation is required. Enter any random number for the
ESI address if the PC will not be connected to a network.
4. After the NIC software is successfully loaded, select the SwchBIOS folder
on the CD-ROM. Click and drag the swbios.exe file from the SwchBIOS folder onto
your desktop to install SwitchBIOS Ver 4.0. This is a self extracting file.
5. Refer to document Setup-Init.pdf (2 pages) in the Documentation folder
to then proceed with the ATM SWITCHStAR Reference Design hardware setup
and configuration.
If you have questions please contact your local IDT Field Applications
Engineer, call (408) 754-4613, or Email switchstarhelp@idt.com.
SWITCHStAR is a registered trademark of Integrated Device Technology, Inc.
本文来源:https://www.2haoxitong.net/k/doc/5f0808a30029bd64783e2cde.html
文档为doc格式